HP ML5590/91 User Manual download pdf (Page 35)

MENU MODE > 35

EXPLANATION OF MENU ITEMS

These explanations are in alphabetical sequence to make it easier to

look them up. Some items only appear when optional accessories are

installed; others appear in several groups in the menu.

Auto CR, Default =No

IBM emulation only. If you want the printer to automatically add a

carriage return when a Line Feed is received at the end of a line,

change the setting to Yes.

Auto LF, Default = No

If your printout is consistently double spaced, select No; if it

overprints, select Yes.

Auto Feed XT, Default = Invalid

Epson emulation only. In the Epson emulation, the XT signal on pin 14

of the parallel interface can control automatic line feed. Some

interface cables are wired in such a way that automatic line feed is

always in effect: this item eliminates this potential problem. If your

system uses pin 14 of the parallel interface to control automatic line

feed, change the setting to Valid.

Auto Select, Default = No

Determines whether or not your printer will automatically be selected

after you load in paper. With the factory default engaged, the printer

will be deselected so that you can set the Top of Form. If you always

use the same Top of Form position, change the setting to Yes.

Baud Rate, Default = 9600 bps

Appears only if optional Serial Interface is installed. Set this to match

your system’s transmission speed.

Bi-direction, Default = Enable

Change this setting if you wish to disable bi-directional transmission

(PnP) in Nibble mode.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 95 96

No comments

HP ML5590/91 User Manual Page 35