HP ML5590/91 User Manual download pdf (Page 40)

MENU MODE > 40

Paper Out Override, Default = No

Senses when less than 1" (25 mm) of paper remains and stops

printing. Change to Yes to override the sensor and print closer to the

bottom of the page.

Parity, Default = None

Appears only when the optional Serial Interface is installed. Selects

the type of parity your system uses: None, Odd or Even.

Pin 18, Default = +5V

Sets the signal on pin 18 to +5 volts or open.

Pitch, Default = 10 cpi

Choose the character width in characters per inch (cpi).

Power Save Time, Default = 5 min.

Sets the interval the printer waits for more data before it goes into the

power save mode. Power Saving must be set to Enable (the factory

default) for this to be effective.

Power Saving, Default = Enable

Change to Disable if you wish to prevent the printer from entering the

Power Save mode after the selected interval.

Print Mode, Default = LQ Courier

Choose the quality and typeface of printing.

Print Registration, Default = 0

Change the setting as required to obtain the best registration for bi-

directional printing.

CAUTION!

Engaging Paper Out Override can cause loss of data and damage the

printhead by allowing printing without paper.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 95 96

No comments

HP ML5590/91 User Manual Page 40