HP ML5590/91 User Manual download pdf (Page 12)

PRINTER DRIVERS > 12

The printer will be identified

immediately by the New Hardware

Wizard and install itself in the Printer

folder. An additional item, USB Printing

Support will also appear in the Device

Manager each time the printer is

switched

and connected.

Check that the default paper size has

been correctly set by looking at the

settings in the Settings > Printers folder.

Under the printer's Properties > General

tab, the current paper selection is

shown. The printer picks up its initial

setting from the Locale settings on the

host computer. The paper size can be

altered by using the drop down arrow

and selecting an alternative size.

If the printer had formerly been used as a parallel or serial

device and there is no output from the printer once a USB

cable has been connected, check to see that the correct port

has been selected. This information can also be found in the

Properties folder but under the Ports tab. Amend as necessary.

If there are printing problems, check to see whether there is a

USB connection active in the Control Panel. If there is no USB

connection shown, you must install the hub.

Alternatively, there may be a problem if the printer is

connected via a USB hub. Disconnect the printer cable from

the hub and connect it directly to the computer.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 95 96

No comments

HP ML5590/91 User Manual Page 12