NOTE: If the bezel button menu assigned by default to Display Info has been changed, you can also access
the Information menu via the Main menu.
You can also assign a static IP address to the display, as follows:
1. Press one of the front bezel buttons to display the button labels, and then press the Open Menu button
to open the OSD.
2. Select Management.
3. Select Remote management services, and then press Select to open it.
4. Select IP conguration mode, and then press Select to open it.
5. Choose Manual, and then press Select to switch to static IP address mode.
The IPv4 Address, Subnet Mask, and Gateway options become active and the cursor jumps to the rst
entry in the IPv4 Address.
6. Use the bezel buttons to enter the required Address, Subnet Mask, and Gateway numbers.
The bezel buttons allow you to increase or decrease the numerical value of entry and move between
entries.
7. Press Back when you have completed the IP address conguration.
Setting dashboard security
By default, the web dashboard only requires a password. The default password is “DreamColor”, and you can
reset it when you rst log in to the dashboard. If you forget the password, you can reset it to “DreamColor”
from the Remote management services menu.
To reset the default password:
1. Press one of the front bezel buttons to display the button labels, and then press the Open Menu button
to open the OSD.
2. Select Management.
3. Select Remote management services.
4. Select Reset administrator password.
5. Select OK to reset the password to ‘DreamColor’.
You can also require the use of user digital certicates. Any properly issued digital certicate works with the
display. Certicates require that users connecting to the display know the display password and have the
correct certicate stored in their computer.
Additional steps are required to use certicates. You must rst request and receive a unique digital certicate,
either from your IT department or a certicate authority on the Internet.
Once you have a certicate, install it on the computer you use to connect to the display. Refer to your
operating system help or documentation for information on how to install certicates. Then set the display to
use certicates, and install the same certicate on the display.
To congure the display to use certicates and to install a certicate on the display:
1. Press one of the front bezel buttons to display the button labels, and then press the Open Menu button
to open the OSD.
2. Select Management.
3. Select Remote management services.
Conguring remote management 91
Comments to this Manuals