Hp Unified Extensible Firmware Interface User Manual download pdf (Page 10)

3. To navigate through and modify settings in the menu-driven interface, use the keys defined in

the following table.

ActionKey

Press to change a selection.Up or down arrow

Press to select an entry.Enter

Press to go back to the previous screen.ESC

Press to view online help about a selected option.F1

Press to load default RBSU configuration settings. You need to reboot

the system for changes to take effect. Press Enter to apply defaults.

Press ESC if you want to cancel.

Press to save your changes.F10

POST screen keys

Press during server POST or system reboot to display the System

Utilities screen in the iLO 4 Remote Console.

Press during server POST to boot to the One-Time Boot Menu screen.F11

4. To exit the System Utilities screen and restart the server, press Esc until the main menu is

displayed. Exit the utility by selecting Exit and Resume Boot in the main menu.

Rebooting the Server

To reboot the server:

1. From a server running the iLO Remote Console screen, at the top of the menu bar in the System

Utilities screen, select Power Switch.

2. Select Cold Boot to reboot the server.

The screen displays the booting process and the HP ProLiant screen appears where the System

Utilities screen can be accessed by pressing F9.

Towards the end of the boot process, the boot options screen is displayed. This screen is

visible for several seconds before the system attempts to boot from a supported boot device.

During this time, the System Utilities can be accessed by pressing F9.

3. From a server not running the iLO Remote Console, press the power button to shutdown the

server. Press it again to reboot the server.

10 Introduction

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 157 158

No comments

Hp Unified Extensible Firmware Interface User Manual Page 10