HP rp7410 User's Guide download pdf (Page 74)

Table 4-1 Windows SAC Commands (continued)

DescriptionSAC Command

Display the Windows nPartition identification information.

Kill the given process.

k pid

Lower the priority of a process to the lowest possible.

l pid

Lock access to Command Prompt channels.

lock

Limit the memory usage of a process to MB-allow.

m pid MB-allow

Toggle paging the display.

Raise the priority of a process by one.

r pid

Display the current time and date (24 hour clock used).

Set the current time and date (24 hour clock used).

s mm/dd/yyyy hh:mm

Display tlist info (a list of Windows processes running on the nPartition).

Restart the system immediately.

restart

Shutdown the system immediately. This puts the nPartition in a shutdown for reconfig

(inactive) state.

To boot the nPartition (make it active), use the BO command at the service processor

Command menu.

shutdown

Crash the Windows system running on the nPartition. You must have crash dump enabled.

crashdump

Accessing and Using the Service Processor

This section describes how to login to the service processor (MP or GSP) for a server complex.

You can connect to the service processor for a server complex by using the following methods:

• Connecting through the customer LAN port by using telnet, if login access through the

customer LAN is enabled for the service processor.

On HP Superdome servers, the customer LAN hardware is labeled "Customer LAN". On

HP rp8400 servers it is "GSP LAN". On HP rp7405/rp7410 servers it is the only LAN port

on the core I/O.

Use telnet to open a connection with the service processor, then login by entering the

account name and corresponding password.

• Connecting through the local RS-232 port using a direct serial cable connection.

On HP Superdome server hardware, the local RS-232 port is labeled "Local RS-232". On HP

rp8400 servers it is the "Local Console" port. On HP rp7405/rp7410 servers it is the 9-pin

D-shaped connector (DB9) labeled "Console".

• Connecting through the remote RS-232 port using external modem (dial-up) access, if remote

modem access is configured.

On HP Superdome server hardware, the remote RS-232 port is labeled "Remote RS-232". On

HP rp8400 servers it is the "Remote Console" port. On HP rp7405/rp7410 servers it is the

DB9 connector labeled "Remote".

74 Using Management Interfaces and Tools

1 2 ... 69 70 71 72 73 74 75 76 77 78 79 ... 265 266

Comments to this Manuals

No comments

HP rp7410 User's Guide Page 74

Comments to this Manuals

Related products and manuals for Software HP rp7410