HP rp7410 User's Guide download pdf (Page 119)

2. Issue the shutdown command with the appropriate command-line options.

The command-line options you specify dictate the way in which HP-UX is shut down,

whether the nPartition is rebooted, and whether any nPartition configuration changes

(adding or removing cells) take place.

Use the following list to choose an HP-UX shutdown option for your nPartition:

• Shut down HP-UX and halt the nPartition.

On HP 9000 servers only, issue the shutdown -h command to shut down and halt the

nPartition. This leaves the nPartition and all its cells in an active state after HP-UX shuts

down and halts.

To reboot a halted nPartition, you must reset the nPartition using the RS command at

the GSP command menu.

On cell-based HP Integrity servers, the shutdown -h command puts an nPartition

into the shutdown for reconfig state; for details refer to the discussion of shutdown

-R -H in this list.

• Shut down HP-UX and reboot the nPartition.

Issue the shutdown -r command to shut down and reboot the nPartition.

On cell-based HP Integrity servers, the shutdown -r command is equivalent to the

shutdown -R command.

• Perform a reboot for reconfig of the nPartition.

Issue the HP-UX shutdown -R command to perform a reboot for reconfig.

This shuts down HP-UX, reconfigures the nPartition if needed, and reboots the

nPartition.

• Reboot the nPartition and put it into the shutdown for reconfig state.

Use the HP-UX shutdown -R -H command to hold the nPartition in the shutdown

for reconfig state.

This leaves the nPartition and all its cells in an inactive state (the nPartition can be

reconfigured remotely), unless the normal behavior has been modified. For details on

changing OS halt behavior on rx8620 and rx7620 servers, refer to “ACPI Softpowerdown

Configuration—OS Shutdown Behavior” (page 93).

To reboot the nPartition, you must do so manually by using the BO command at the

management processor Command menu.

If HP-UX is halted on the nPartition, thus not allowing you to use the shutdown command,

you can reboot or reset the nPartition by issuing commands from the management processor

Command menu.

Booting and Shutting Down HP OpenVMS I64

This section has procedures for booting and shutting down HP OpenVMS I64 on cell-based HP

Integrity servers and procedures for adding HP OpenVMS to the boot options list.

• To check whether the cell local memory (CLM) configuration is appropriate for HP OpenVMS,

refer to “HP OpenVMS I64 Support for Cell Local Memory” (page 120).

• To add an HP OpenVMS entry to the boot options list refer to “Adding HP OpenVMS to

the Boot Options List” (page 120).

• To boot HP OpenVMS on a cell-based HP Integrity server refer to “Booting HP OpenVMS”

(page 122).

• To shut down HP OpenVMS refer to “Shutting Down HP OpenVMS” (page 123).

Booting and Shutting Down HP OpenVMS I64 119

1 2 ... 114 115 116 117 118 119 120 121 122 123 124 ... 265 266

Comments to this Manuals

No comments

HP rp7410 User's Guide Page 119

Comments to this Manuals

Related products and manuals for Software HP rp7410