HP rp7410 User's Guide download pdf (Page 243)

A nPartition Commands

This appendix has details and command-line syntax for the HP nPartition Commands, including

both the Original nPartition Commands and the Enhanced nPartition Commands.

• The Original nPartition Commands were distributed as part of HP-UX 11i v1 (B.11.11)

releases prior to the December 2004 release.

• The Enhanced nPartition Commands are distributed with current HP-UX releases, including

HP-UX 11i v3 (B.11.31), all releases of HP-UX 11i v2 (B.11.23), and releases of HP-UX 11i v1

(B.11.11) beginning with the December 2004 release.

The Enhanced nPartition Commands also are distributed as bundles on the HP Smart Setup

CD for Windows, and as bundles on the HP Integrity Essentials Foundation Pack for Linux.

For an introduction to the nPartition Commands, see “Commands for Configuring nPartitions”

(page 19). This appendix provides the following reference information for using HP nPartition

Commands:

• “parcreate Command” (page 249)

• “parmodify Command” (page 252)

• “parremove Command” (page 256)

• “parstatus Command” (page 258)

• “parunlock Command” (page 260)

• “fruled Command” (page 262)

• “frupower Command” (page 264)

• “cplxmodify Command” (page 266) — Only supported by the Enhanced nPartition

Commands.

NOTE: For the most current information for these commands, refer to the online manpages:

parcreate(1M), parmodify(1M), parremove(1M), parstatus(1), parunlock(1M), fruled(1M), frupower(1M),

and cplxmodify(1M).

On a Windows system, refer to Start→Programs→He wlett-Packard→nP ar Management→nP ar

Commands Manual.

Specifying Cells and I/O Chassis to Commands

Use the cell and I/O chassis notation described in this section when you manage, configure, and

inquire about cells and I/O chassis using the nPartition configuration commands.

Details are in the “Cell Specification Formats” and “I/O Specification Format” sections that follow.

Cell Specification Formats

Use either of the following two formats to specify cells when using the nPartition configuration

commands: “Global Cell Number Format” or “Cell Hardware Location Format”.

• Global Cell Number Format The global cell number format is identical to the cells' HP-UX

hardware path, as reported by the HP-UX ioscan command. In global format, each cell is

given a single unique number that indicates the relative location of the cell in the entire

server complex.

Table A-1 Cell IDs in Global Cell Number Format

76543210Cell Slot

——————10Global Format for

rp7405/rp7410, rp7420,

rp7440, rx7620, and

rx7640

Specifying Cells and I/O Chassis to Commands 243

1 2 ... 238 239 240 241 242 243 244 245 246 247 248 ... 265 266

Comments to this Manuals

No comments

HP rp7410 User's Guide Page 243

Comments to this Manuals

Related products and manuals for Software HP rp7410