HP D8C84UT#ABA User Manual download pdf (Page 46)

3. Exit the operating system.

4. Remove any compact disc or media card from the computer.

5. Turn off the computer and any peripheral devices that are connected to it.

CAUTION: Turn off the computer before disconnecting any cables.

Regardless of the power-on state, voltage is always present on the system board as long as the

system is plugged into an active AC outlet. In some systems the cooling fan is on even when the

computer is in the “Standby,” or “Suspend” modes. The power cord should always be

disconnected before servicing a unit.

6. Disconnect the power cord from the electrical outlet and then from the computer.

7. Disconnect all peripheral device cables from the computer.

NOTE: During disassembly, label each cable as you remove it, noting its position and routing.

Keep all screws with the units removed.

CAUTION: The screws used in the computer are of different thread sizes and lengths; using

the wrong screw in an application may damage the unit.

38 Chapter 7 Removal and Replacement Procedures Small Form Factor (SFF) Chassis

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 159 160

No comments

HP D8C84UT#ABA User Manual Page 46