HP 280 G1 Specifications download pdf (Page 37)

c. If you are removing a PCI Express x16 card, pull the retention arm on the back of the expansion

socket away from the card and carefully rock the card back and forth until the connectors pull free

from the socket. Lift the card straight up to remove it. Be sure not to scrape the card against other

components.

6. Store the removed card in anti-static packaging.

7. If you are not installing a new expansion card, install an expansion slot cover to close the open slot.

CAUTION: After removing an expansion card, you must replace it with a new card or expansion slot

cover for proper cooling of internal components during operation.

8. To install a new expansion card, hold the card just above the expansion socket on the system board

then move the card toward the rear of the chassis so that the bottom of the bracket on the card slides

into the small slot on the chassis. Press the card straight down into the expansion socket on the system

board.

NOTE: When installing an expansion card, press firmly on the card so that the whole connector seats

properly in the expansion card slot.

9. Connect external cables to the installed card, if needed. Connect internal cables to the system board, if

needed.

10. Replace the computer access panel.

11. Reconnect the power cord and turn on the computer.

12. Lock any security devices that were disengaged when the computer access panel was removed.

13. Reconfigure the computer, if necessary.

Expansion cards 29

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 135 136

No comments

HP 280 G1 Specifications Page 37