HP E1Z74UT User Manual Page 202
- Page / 245
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
Control panel message Description Recommended action
1152-Serial Port B Address Conflict Detected Both external and internal serial ports are
assigned to COM2.
1. Remove any serial port expansion
cards.
2. Clear CMOS. (See Appendix B,
Password security and resetting CMOS
on page 200.)
3. Reconfigure card resources and/or run
Computer Setup or Windows utilities.
1155-Serial Port Address Conflict Detected Both external and internal serial ports are
assigned to same IRQ.
1. Remove any serial port expansion
cards.
2. Clear CMOS. (See Appendix B,
Password security and resetting CMOS
on page 200.)
3. Reconfigure card resources and/or run
Computer Setup or Windows utilities.
1720-SMART Hard Drive Detects Imminent
Failure
Hard drive is about to fail. (Some hard
drives have a hard drive firmware patch that
will fix an erroneous error message.)
1. Determine if hard drive is giving correct
error message. Enter Computer Setup
and run the Drive Protection System test
under Storage > DPS Self-test.
2. Apply hard drive firmware patch
if applicable. (Available at
http://www.hp.com/support.)
3. Back up contents and replace hard
drive.
1796-SATA Cabling Error One or more SATA devices are improperly
attached. For optimal performance, the
SATA 0 and SATA 1 connectors must be
used before SATA 2 and SATA 3.
Ensure SATA connectors are used in
ascending order. For one device, use SATA
0. For two devices, use SATA 0 and SATA
1. For three devices, use SATA 0, SATA 1,
and SATA 2.
1797-SATA Drivelock is not supported in
RAID mode.
Drivelock is enabled on one or more SATA
hard drives, and they cannot be accessed
while the system is configured for RAID
mode.
Either remove the Drivelocked SATA device
or disable the Drivelock feature. To disable
the Drivelock feature, enter Computer Setup,
change Storage > Storage Options >
SATA Emulation to IDE, and select File >
Save Changes and Exit. Reenter
Computer Setup and select Security >
Drivelock Security. For each listed
Drivelock-capable SATA device, ensure
Drivelock is Disabled. Lastly, change
Storage > Storage Options > SATA
Emulation back to RAID and select File >
Save Changes and Exit.
1801-Microcode Patch Error Processor is not supported by ROM BIOS.
1. Upgrade BIOS to proper version.
2. Change the processor.
192 Chapter 9 POST error messages
- Maintenance and Service Guide 1
- About This Book 3
- Table of contents 5
- 1 Product features 11
- Small Form Factor (SFF) 12
- Serial number location 17
- Software 18
- Windows 8 19
- Downloading Windows 8 updates 20
- 3 Illustrated parts catalog 21
- Misc parts 24
- Misc boards 26
- Computer major components 30
- Spare part 37
- Description 37
- 732772-001 Solenoid lock 37
- 4 Routine care, SATA drive 38
- Generating static 39
- Grounding the work area 40
- Operating guidelines 41
- Routine care 42
- Service considerations 43
- Cables and connectors 44
- Hard Drives 44
- SATA hard drives 45
- SATA hard drive cables 46
- SMART ATA drives 46
- Cable management 46
- 5 Removal and replacement 47
- Access panel 48
- Front bezel security 49
- Front bezel 50
- Expansion cards 56
- No. Guide Screw Device 62
- Removing a 5.25-inch drive 64
- Installing a 5.25-inch drive 64
- Power switch/LED assembly 78
- Speaker 645330-001 83
- Solenoid lock 641498-001 84
- Fan 636922-001 88
- 6 Removal and replacement 95
- Bezel blanks 100
- DDR3-SDRAM DIMMs 101
- Populating DIMM sockets 101
- Installing DIMMs 102
- Expansion card 104
- System board connections 108
- Drive positions 111
- Removing a 3.5-inch device 112
- Installing a 3.5-inch device 113
- Removing a slim optical drive 115
- Power supply 122
- Fan duct 125
- Description Spare part number 126
- Solenoid lock 732772-001 126
- Hood sensor 129
- Cable routing 130
- Front I/O assembly 131
- Power switch assembly 133
- Speaker 727149-001 135
- Fan sink 136
- Processor 137
- System board 139
- Computer Setup—File 144
- Computer Setup—Storage 145
- Computer Setup—Security 148
- Computer Setup—Power 153
- Computer Setup—Advanced 155
- 8 Troubleshooting without 158
- Helpful hints 159
- Solving general problems 161
- Solving power problems 165
- Solving hard drive problems 166
- Solving display problems 170
- Solving audio problems 176
- Solving printer problems 178
- Solving Network Problems 184
- Solving memory problems 187
- Solving processor problems 189
- Solving software problems 195
- 9 POST error messages 197
- Resetting the password jumper 211
- 11 HP PC Hardware Diagnostics 214
- 12 System backup and recovery 216
- Using Windows 8 Refresh 218
- Using Windows 8 Reset 219
- Creating recovery media 222
- System Restore 225
- System Recovery 226
- A Battery replacement 230
- Smart cover FailSafe key 233
- C Power cord set requirements 236
- Country-specific requirements 237
- D Specifications 238
- SFF specifications 239
- Rated Input Current 4A 240
Related products and manuals for Server/workstation motherboards HP E1Z74UT
(248 pages)
(112 pages)
© 2020, manymanuals.com. All rights reserved. | 1.160 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals