Hp Officejet 7612 Wide Format e-All-in-One User Manual Page 139

  • Download
  • Add to my manuals
  • Print
  • Page
    / 317
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 138
The "Fax Hardware Test" failed
Solution:
Turn the printer off by pressing the
(Power) button located on the printer control panel and
then unplug the power cord from the back of the printer. After a few seconds, plug the power
cord in again, and then turn the power on. Run the test again. If the test fails again, continue
reviewing the troubleshooting information in this section.
Try to send or receive a test fax. If you can send or receive a fax successfully, there might not be
a problem.
If you are running the test from the Fax Setup Wizard (Windows) or HP Setup Assistant (Mac
OS X), make sure the printer is not busy completing another task, such as receiving a fax or
making a copy. Check the display for a message indicating that the printer is busy. If it is busy,
wait until it is finished and in the idle state before running the test.
Make sure you use the phone cord that came with the printer. If you do not use the supplied
phone cord to connect from the telephone wall jack to the printer, you might not be able to send
or receive faxes. After you plug in the phone cord that came with the printer, run the fax test
again.
If you are using a phone splitter, this can cause faxing problems. (A splitter is a two-cord
connector that plugs into a telephone wall jack.) Try removing the splitter and connecting the
printer directly to the telephone wall jack.
After you resolve any problems found, run the fax test again to make sure it passes and the printer is
ready for faxing. If the Fax Hardware Test continues to fail and you experience problems faxing,
contact HP support. Go to
www.hp.com/support. This website provides information and utilities that
can help you correct many common printer problems. If prompted, select your country/region, and
then click Contact HP for information on calling for technical support.
The "Fax Connected to Active Telephone Wall Jack" test failed
Solution:
Check the connection between the telephone wall jack and the printer to make sure the phone
cord is secure.
Make sure you use the phone cord that came with the printer. If you do not use the supplied
phone cord to connect from the telephone wall jack to the printer, you might not be able to send
or receive faxes. After you plug in the phone cord that came with the printer, run the fax test
again.
Make sure you have correctly connected the printer to the telephone wall jack. Using the phone
cord supplied in the box with the printer, connect one end to your telephone wall jack, then
connect the other end to the port labeled 1-LINE on the back of the printer. For more information
on setting up the printer for faxing, see
Additional fax setup on page 206.
If you are using a phone splitter, this can cause faxing problems. (A splitter is a two-cord
connector that plugs into a telephone wall jack.) Try removing the splitter and connecting the
printer directly to the telephone wall jack.
122 Chapter 8 Solve a problem ENWW
Page view 138
1 2 ... 134 135 136 137 138 139 140 141 142 143 144 ... 316 317

Comments to this Manuals

No comments