HP Proliant ML350 Generation 3 Installation Guide Page 55

  • Download
  • Add to my manuals
  • Print
  • Page
    / 197
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 54
Overview of Server Installation
Installing the Cable Management Arm
The cable management arm secures to the cable management arm bracket that was
previously installed. See “Installing the Cable Management Arm Bracket” section
earlier in this chapter. All cables running to and from the server are secured to this
arm. The cable management arm allows the cables to swing out of the way when the
server is accessed.
To install the cable management arm:
1. Slide the server into the rack. See “Installing the Server into the Rack” earlier in
this chapter.
2. Secure the server end of the cable management arm (1) to the cable management
arm bracket (located on the server) by pulling out on the spring-loaded
fastener (2), inserting the locking tab (3) into the cable management arm bracket,
releasing the spring-loaded fastener, and pushing down until the spring-loaded
fastener engages.
1
3
2
Figure 2-16: Securing the cable management arm to the
bracket
3. Align the other end of the cable management arm with the inside of the left rear
rack frame mounting bracket (mounted on rear of left side slide assembly).
HP ProLiant ML350 Generation 3 Server Setup and Installation Guide 2-25
HP CONFIDENTIAL
Writer: Richard O. Heath File Name: c-ch2 Overview of Server Installation.doc
Codename: Steel Venom Part Number: 316354-001 Last Saved On: 12/6/02 2:56 PM
Page view 54
1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 196 197

Comments to this Manuals

No comments