HP Proliant ML350 Generation 3 Installation Guide download pdf (Page 116)

Cabling Guidelines

Storage Device Installation Guidelines

Consider the following guidelines when adding SCSI devices:

As a general rule, a maximum of seven devices may be added per channel. The

server is equipped with two integrated Ultra3 SCSI channels.

The configuration settings on each SCSI device should be set to the SCSI ID of

the bay (Bay 0 = SCSI ID 0) that it will occupy.

If only one SCSI hard drive is used, it should be installed in the lowest-numbered

bay (0).

Be sure to remove all terminating jumpers from third-party SCSI devices.

CAUTION: To prevent damage to the equipment, be sure that the server is powered

down, all cables are disconnected from the back of the server, and the power cord is

disconnected from the grounded (earthed) AC outlet before installing devices.

CAUTION: Electrostatic discharge (ESD) can damage electronic components. Be

sure that you are properly grounded (earthed) before beginning any installation

procedure. Refer to Appendix B, “Electrostatic Discharge,” for more information.

4-2 HP ProLiant ML350 Generation 3 Server Setup and Installation Guide

HP CONFIDENTIAL

Writer: Richard O. Heath File Name: e-ch4 Cabling Guidelines.doc

Codename: Steel Venom Part Number: 316354-001 Last Saved On: 12/9/02 8:20 AM

1 2 ... 111 112 113 114 115 116 117 118 119 120 121 ... 196 197

No comments

HP Proliant ML350 Generation 3 Installation Guide Page 116