HP Proliant ML350 Generation 3 Installation Guide download pdf (Page 82)

Hardware Options Installation

Installing a Tape Drive

To install a tape drive:

CAUTION: To prevent damage to equipment or loss of information, be sure that the

server is powered down, all cables are disconnected from the server, and the power

cord is disconnected from the grounded (earthed) AC outlet before removing the

access panel.

1. Remove the access panel (and bezel door if applicable) by following the steps in

the section applicable to your tower or rack server at the beginning of this

chapter.

2. Install guide screws on the sides of the drive.

3. To configure the device, set the SCSI device ID. You must manually set the SCSI

device ID on each device to a unique value in the range of 0 through 5 for each

SCSI bus. Refer to the documentation provided with the drive for instructions on

setting the SCSI device ID.

4. Slide the drive into the drive bay until it clicks into place.

Figure 3-15: Installing a tape drive (DLT)

IMPORTANT: HP recommends installing the tape drive on a separate SCSI cable to avoid a

decrease in performance of other SCSI devices.

3-18 HP ProLiant ML350 Generation 3 Server Setup and Installation Guide

HP CONFIDENTIAL

Writer: Richard O. Heath File Name: d-ch3 Hardware Options Installation.doc

Codename: Steel Venom Part Number: 316354-001 Last Saved On: 12/6/02 3:06 PM

1 2 ... 77 78 79 80 81 82 83 84 85 86 87 ... 196 197

No comments

HP Proliant ML350 Generation 3 Installation Guide Page 82