HP Proliant ML350 Generation 3 Installation Guide Page 84

  • Download
  • Add to my manuals
  • Print
  • Page
    / 197
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 83
Hardware Options Installation
Removing a Device from Removable Media Bay
To remove a tape drive or other device:
CAUTION: To prevent damage to equipment or loss of information, be sure that the
server is powered down, all cables are disconnected from the server, and the power
cord is disconnected from the grounded (earthed) AC outlet before removing the
access panel.
1. Remove the access panel (and bezel door if applicable) by following the steps in
the section applicable to your tower or rack server at the beginning of this
chapter.
2. Disconnect the power cable and data cable from the back of the tape drive.
Figure 3-17: Disconnecting the power and data cables
3-20 HP ProLiant ML350 Generation 3 Server Setup and Installation Guide
HP CONFIDENTIAL
Writer: Richard O. Heath File Name: d-ch3 Hardware Options Installation.doc
Codename: Steel Venom Part Number: 316354-001 Last Saved On: 12/6/02 3:06 PM
Page view 83
1 2 ... 79 80 81 82 83 84 85 86 87 88 89 ... 196 197

Comments to this Manuals

No comments