HP 445942-001 User Manual Page 163

  • Download
  • Add to my manuals
  • Print
  • Page
    / 199
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 162
Configuration Commands
163
Virtual Router Redundancy Protocol configuration
Virtual Router Redundancy Protocol (VRRP) support on the HP 10GbE switch provides redundancy
between routers in a LAN. This is accomplished by configuring the same virtual router IP address and ID
number on each participating VRRP-capable routing device. One of the virtual routers is then elected as
the master, based on a number of priority criteria, and assumes control of the shared virtual router IP
address. If the master fails, one of the backup virtual routers will assume routing authority and take control
of the virtual router IP address.
By default, VRRP is disabled. For more information on VRRP, see the “High Availability” chapter in the
HP 10Gb Ethernet BL-c Switch Application Guide.
The following table describes the basic VRRP Configuration commands. The following sections provide
more detailed information and commands.
Table 147 VRRP Configuration commands
Command Description
router vrrp
Enter VRRP configuration mode.
Command mode: Router VRRP
enable
Globally enables VRRP on this switch.
Command mode: Router VRRP
no enable
Globally disables VRRP on this switch.
Command mode: Router VRRP
show ip vrrp
Displays the current VRRP parameters.
Command mode: All except User EXEC
Page view 162
1 2 ... 158 159 160 161 162 163 164 165 166 167 168 ... 198 199

Comments to this Manuals

No comments