HP ProCurve 9315M User Manual download pdf (Page 52)

Release Notes for 07.8.04 Software Fixes

65342 When detecting a port lockup condition on a routing

switch, a system reload may occur.

System 07.8.02

65418 If you configure the Port Security feature with an

ACL that permits Internet Control Message Protocol

(ICMP) traffic, ICMP packets may sometimes be

dropped.

System 07.8.02

65740 If IGMP snooping is configured, the switch

incorrectly forwards the IGMP report to a client port,

causing the host to suppress its reports. This results

in the multicast stream being pruned prematurely.

IGMP

Snooping

07.8.02

66444 A system reload may occur on a routing switch

when a packet with an invalid source port field in the

internal packet header is received.

System 07.8.02

67266 If sFlow and Layer 4 services are configured,

collecting sFlow-specific Layer 3 information for

export from a sampled packet may result in a

system reload.

sFlow 07.8.02

67734 On an interface on which UDLD is configured, the

logical link does not come up.

UDLD 07.8.02

07.8.03

55771 If OSPF is configured, an OSPF route is not

removed from the OSPF routing table when the

source of the route is removed.

OSPF 07.8.03

56958 Deleting a MAC address entry from CAM can

sometimes cause a system reload.

System 07.8.03

62887 If OSPF is configured, the OSPF cost configured on

Gigabit interfaces does not take effect.

OSPF 07.8.03

62982 On an EP 48-Port 10/1000-TX RJ45 module, MDI/

MDIX capability does not function correctly after you

reconfigure an interface from 100M full-duplex to

auto-negotiation mode.

System 07.8.03

63081 On an EP 48-Port 10/1000-TX RJ45 module, a 10M

full-duplex interface shows some packet loss while

processing incoming packets.

System 07.8.03

63830 If VRRP is configured, if the interface using the

VRRP master port is disabled, a gratuitous ARP

packet with the physical MAC address is

transmitted.

VRRP 07.8.03

65526 After you remove a 10 Gigabit Ethernet module with

XENPAK optics from a routing switch, the module

cannot be re-inserted without causing a system

reload.

System 07.8.03

Bug ID Bug Description Protocol/

Feature

Version

Found

Version

Fixed

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 65 66

Comments to this Manuals

No comments

HP ProCurve 9315M User Manual Page 52

Comments to this Manuals

Related products and manuals for Network switch modules HP ProCurve 9315M