HP ProCurve 9315M User Manual download pdf (Page 29)

Software Fixes Release Notes for 07.8.04

07.8.01

14668 Although rare in occurrence, in some configurations

with EBGP, IBGP, and OSPF routes, a routing

switch may not always select the best route. For

example, the device might install an IBGP route in

the routing table, even though the IBGP route has a

higher administrative distance than OSPF. This

could happen if the switch previously selected an

EBGP route as the best route.

If this problem occurs, you must clear the routing

table for a routing switch to select the best route.

BGP 07.8.01

25042 On the EP 8 Port Mini-GBIC Redundant

Management module, if you configure a port name

on the primary port of a trunk group, the switch

generates an error message when it boots up. For

example, the following configuration generates an

error at boot-up:

ProCurve(config)#interface ethernet

1/3

ProCurve(config-if-e1000-1/3)# port-

name “testtrunk”

However, if you configure a port name on all of the

members of the trunk group, this error does not

occur. For example:

ProCurve(config)#trunk switch ethernet

1/3 to 1/4

ProCurve(config-trunk-1/3-1/4)#port-

name “testtrunk”

CLI 07.8.01

25049,

25455

A port operating at 10-half (10 Mbps at half duplex)

drops 80% of broadcast traffic to other ports in the

VLAN. This does not occur if the port is configured

to operate at 100-full.

IP Stack 07.8.01

29177 On an 8 Port Mini-GBIC Redundant Management

module, a deny clause in an outbound ACL does

not filter traffic correctly if the destination IP address

has been aggregated using the IP net aggregate

command.

ACL 07.8.01

29465 On an EP 24 Port 100Base-FX module (J8178A),

MRP disables 10/100 copper MRP ring interfaces

that are set to 100-full speed and duplex mode. In

addition, the show interface brief command output

displays the interfaces as “blocked”.

24-port 10/100

Module

07.8.01

29469 The peer MAC address or IP field for the VSRP

standby displays “unknown” even if the VSRP

standby knows the IP address of the master routing

switch.

VSRP 07.8.01

Bug ID Bug Description Protocol/

Feature

Version

Found

Version

Fixed

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 65 66

Comments to this Manuals

No comments

HP ProCurve 9315M User Manual Page 29

Comments to this Manuals

Related products and manuals for Network switch modules HP ProCurve 9315M