HP ProCurve 9315M User Manual download pdf (Page 53)

Software Fixes Release Notes for 07.8.04

65528 Removing a module from a routing switch may

cause Port Database entries on the module to be

inaccessible, resulting in a system reload.

System 07.8.03

66003 After a module is removed from a routing switch, a

syslog message is sometimes generated that lacks

information to sufficiently describe the cause. This

fix provides the following possible causes in the

syslog:

• The module is removed by the user.

• Hardware failure of the module occurred.

• A failure to read Board ID occurred.

System 07.8.03

66207 When 10 Gigabit Ethernet modules (MSA) are

installed, entering the debug command to perform

backplane debugging can sometimes cause a

system reload.

System 07.8.03

67109 If RIPv2 and redistribution are configured and you

remove a static route, an incorrect metric instead of

a poison metric of 16 is sent out.

RIPv2 07.8.03

67172 An Inter Process Communication-related message

may cause a system reload.

System 07.8.03

67848 If you configure an IP MTU, the show ip interface

<slot/port> command does not correctly display the

configured IP MTU value.

IP Stack 07.8.03

67854 If you configure an IP MTU and later modify the

MTU value, the new value is not updated.

IP Stack 07.8.03

68140 If you configure OSPF and enable traps, OSPF

neighbor state changes are not logged if the

interface is not the designated router (DR).

OSPF 07.8.03

68295 The configuration of time zones in 30-second

increments is not supported on the Simple Network

Time Protocol (SNTP) clock.

SNTP 07.8.03

68645 When you download an image via INM with the

option to save the configuration on a routing switch,

a log message is generated with an invalid user

name and remote IP address.

System 07.8.03

69093 When you run diagnostics on a routing switch by

using the dm diag command, a system reload may

occur.

System 07.8.03

69140 If you configure a single spanning tree, if the

configuration has a large number of VLANs (several

hundred), a system reload may occur when you

enter the show span command.

Spanning Tree 07.8.03

07.8.03a

Bug ID Bug Description Protocol/

Feature

Version

Found

Version

Fixed

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 65 66

Comments to this Manuals

No comments

HP ProCurve 9315M User Manual Page 53

Comments to this Manuals

Related products and manuals for Network switch modules HP ProCurve 9315M