search

HP ProCurve 9315M User Manual Page 24

  • Download
  • Add to my manuals
  • Print
  • Page
    / 66
  • Table of contents
  • BOOKMARKS
    • Rated. / 5. Based on customer reviews
Page view 23
21
Release Notes for 07.8.04 Software Fixes
49218 LACP implementation causes a trunk instance to be
recreated if a primary trunk port attached to a
Cisco 6500 goes down or comes up.
LACP 07.8.00
49294 If you do not enter the no rfc153-compatibility
command, type 3 summary link-state
advertisements (LSAs) with maximum cost are
sent. To activate the software fix, refer to the RFC
1583-type3-cost.
LSA 07.8.00
51320 In show support l4 command output, IP Content
Addressable Memory (CAM) information is listed for
all slots but is truncated and not displayed after the
first eighteen lines.
CLI 07.8.00
51505/
51606
A memory leak in the web engine occurs because
the http_receive_packet routine is not freed
correctly when a client resets the connection.
System 07.8.00
51959 After you enter the debug ip ospf flood command,
messages are displayed even if LSAs are sent to
the adjacent router.
OSPF 07.8.00
52399 The no ip follow acl command does not work
properly.
ACL 07.8.00
52419 During an SSH session, an SSH client is
disconnected after the configured idle timer expires.
SSH 07.8.00
52617 The system reloads when you add a tagged port to
a VLAN.
VLAN 07.8.00
07.8.00m
36085 A system reload may occur if the MRP ring interface
is enabled.
MRP 07.8.00
42147 There is no command to disable the sending of
SNMP traps for ACL log messages.
ACL 07.8.00
47254 On a tagged port, the incorrect ACL is applied to
packets.
ACL 07.8.00
48029 The system may reload if MRP is configured. MRP 07.8.00
50734 A log entry is only generated for permitted host; a
log entry is not generated for a permitted network.
System 07.8.00
50939 The no access-list command leaks a denied
packet although the ACL is not related to the
interface.
ACL 07.8.00
51696 An SSHv2 key sometimes fails synchronize with a
standby module after you enter the write memory
command or after a boot-up.
SSH 07.8.00
Bug ID Bug Description Protocol/
Feature
Version
Found
Version
Fixed
Page view 23
1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 65 66

Comments to this Manuals

No comments
Related products and manuals for Network switch modules HP ProCurve 9315M
Network switch modules HP G250 User Manual   (76 pages)
Network switch modules HP 409513-B22 Datasheet   (15 pages)
  • Cord Actidata Mopar Anodyne Electronics Manufacturing Alpine Innovation
  • Iogear Interface cards/adapters IBM Tape drives Tek Republic Interface cards/adapters Slant/Fin Water heaters & boilers EVGA Power supply units
  • EVGA inDtube QUAD 405 Electrolux EAP150 White-rodgers 1F85-0477 Behringer EUROLIVE B112D
  • Hyundai H-MW1230 User Manual Jamo IW 626 LCR FG User Manual Sony M-470 User Manual Powermate PM0145500 User Manual Yamaha MONTAGE6 User Manual