HP ProCurve 9315M User Manual Page 31

  • Download
  • Add to my manuals
  • Print
  • Page
    / 66
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 30
Software Fixes Release Notes for 07.8.04
28
31084 On an EP 8 Port Mini-GBIC Redundant
Management module, a system reload occurs when
a BGP packet with an invalid header length is
received.
BGP4+ 07.8.01
31157 A BGP routing switch fails to send notification after
clearing a peer session.
BGP4+ 07.8.01
31166 OSPF fails to delete a redistributed static route from
the routing table even though the static route has
been removed.
OSPF 07.8.01
31543 On an EP 8 Port Mini-GBIC Redundant
Management module, a system reload may occur in
an OSPF configuration when Remote Fault
Notification (RFN) is enabled or disabled on a
Gigabit Ethernet fiber port.
OSPF 07.8.01
31649 If the active EP 8 Port Mini-GBIC Redundant
Management module fails over to the standby
management module, the standby management
module does not inherit the jumbo frame
configuration from the active management module.
Jumbo IP
Packet
Support
07.8.01
31734 A routing switch reloads if its configuration includes
Internet Group Management Protocol (IGMP)
snooping and the hash table has a NULL value.
Other 07.8.01
31925 The copper mini-GBICs can operate in 1000 Mbps
auto-negotiation mode only. You cannot configure
them to operate in other modes. However, if you
insert a mini-GBIC (M-TX) into an LX or SX port, the
CLI allows you to configure the mini-GBIC to a
speed other than 1000 Mbps.
CLI 07.8.01
32021 The routing switch does not decrease the time-to-
live (TTL) value when a VSRP packet is
transmitted.
VSRP 07.8.01
32192 VRRP-E link state flapping (fluctuating between up
and down) causes a system reload. This occurs on
a routing switch in which a non-T-Flow
management module is installed.
Other 07.8.01
32230 On an 8 Port Mini-GBIC Redundant Management
module, when a TCP-established clause is used in
an ACL, the ACL incorrectly permits a series of
synchronization (SYN) packets after it receives an
acknowledgement (ACK) packet with a TTL of 0
(zero).
ACL 07.8.01
Bug ID Bug Description Protocol/
Feature
Version
Found
Version
Fixed
Page view 30
1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 65 66

Comments to this Manuals

No comments