Hp ProLiant ML350 G6 Server User Manual download pdf (Page 44)

Hardware options installation 44

Install the DIMM baffle onto the fan.

10. Install the large redundant fan air baffle, if removed.

11. Install the access panel (on page 27).

12. Do one of the following:

o Close or install the tower bezel, as needed.

o Slide the server back into the rack.

13. Power up the server (on page 24).

Memory options

IMPORTANT: This server does not support mixing RDIMMs and UDIMMs. Attempting to mix

these two types causes the server to halt during BIOS initialization.

The memory subsystem in this server can support RDIMMs or UDIMMs. Both types are referred to as DIMMs

when the information applies to both types. When specified as RDIMM or UDIMM, the information applies

to that type only. All memory installed in the server must be the same type.

The server supports the following DIMM speeds:

• Single- and dual-rank PC3-10600 (DDR-1333) DIMMs operating at 1333 and 1066 MHz

• Quad-rank PC3-8500 (DDR-1067) DIMMs operating at 1066 MHz

Depending on the processor model, the number of DIMMs installed, and whether UDIMMs or RDIMMs are

installed, the memory clock speed may be reduced to 1066 or 800 MHz. For more information on the effect

of DIMM slot population, see "General DIMM slot population guidelines (on page 48)."

Memory subsystem architecture

The memory subsystem in this server is divided into channels. Each processor supports three channels, and

each channel supports three DIMM slots, as shown in the following table.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 143 144

No comments

Hp ProLiant ML350 G6 Server User Manual Page 44