HP ProCurve 5400zl User Manual download pdf (Page 66)

4-6

Replacing Components

Replacing the Management Module Compact Flash Card

Replacing Components

Replacing the Management Module

Compact Flash Card

The Compact Flash card is the primary non-volatile storage medium located

on the management module that contains both the boot software and

configuration files. When a Flash card fails the Flash status LED on the

management module will blink simultaneously with the switch Fault LED.

Installing a Compact Flash Card

To install (or replace) a Compact Flash card:

1. Using either a flat-bladed or Torx T-10 screwdriver loosen the retaining

screws securing the management module. (You cannot access the

Compact Flash when the management module is installed. This prevents

inadvertent removal of the system image while the system is running.)

2. Using the extractor handles, pull the management module out from the

slot.

Figure 4-4. Management Module Removal

3. Slide out the old flash card.

4. Slide in the new flash card being careful not to bend any pins.

5. Reinstall the management module into the switch.

6. Use an equal amount of pressure and push both extractor handles closed

to completely seat the module.

7. Tighten the retaining screws.

Slide out

Compact Flash

Memory disk

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 117 118

No comments

HP ProCurve 5400zl User Manual Page 66