HP ProCurve 5400zl User Manual download pdf (Page 40)

2-16

Installing the Series 5400zl Switches

Installation Procedures

Installing the Series 5400zl

Switches

Figure 2-6. Switch Fault, Module, and Chassis LEDs

When the switch is powered on, it performs its diagnostic self test. The entire

download, initialization, and self test process can take up to 2 minutes for a

fully loaded chassis, depending on the number and type of modules installed

in the switch.

LED Behavior:

During the self test:

■ Initially, Power, Fault, Locator, and all the switch chassis LEDs are on. Then,

after approximately 30 seconds, all the module LEDs go on as the modules

receive power and code is downloaded to them, the Fault LED goes off,

and the chassis LEDs turn orange and then go off except Test, Fan, and

Power, which turn green.

■ When the download of code to the modules is completed, the module

LEDs go off. You may see each port LED go on briefly, in sequence, as the

port is tested.

■ For the duration of the self test, the Test LED stays on.

When the test completes successfully:

■ The Power LED stays on, and the Status LEDs on the switch chassis stay

on for the devices installed: one for each switch module installed, one for

each power supply installed, and one for all the fans.

■ The Fault, Locator, and Test LEDs are off.

■ The port LEDs on the switch modules go into their normal operational

mode:

Switch Fault LED

Switch Module LEDs:

Link and Mode LEDs

for each port

Switch Chassis LEDs

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 117 118

No comments

HP ProCurve 5400zl User Manual Page 40