HP ProCurve 5400zl User Manual download pdf (Page 45)

2-21

Installing the Series 5400zl Switches

Installation Procedures

Installing the Series 5400zl

Switches

6. Install the Grounding Wire

If a grounding wire is to be attached to the switch chassis, the grounding lug

must be removed and a wire crimped to it and the grounding lug must be

reinstalled.

1. Use a #1 Phillips (cross-head) screwdriver and remove the grounding lug

and two screws from the back of the switch.

2. Crimp the grounding lug to a properly grounded grounding wire.

3. Re-attach the grounding lug to the switch with the two screws.

Figure 2-11. Attaching Grounding Lug to the 5400zl Switch

7. Connect the Switch to a Power Source

1. Plug the included power cord into the switch’s power connector and into

a nearby properly grounded AC power source.

If a redundant power source is available, it is desirable to power one

switch power supply from the regular AC source, and the other power

supply from the redundant AC source. This will provide redundancy in AC

power to the switch, as long as the switch PoE power usage falls within

the capability of one power supply. If both power supplies are plugged

into a common AC source, there is still power supply redundancy, that is,

protection against power supply failure, but if the AC source fails, the

switch will lose all power.

2. Re-check the LEDs during self test. See “LED Behavior” on page 2-16.

Grounding lug

Grounding

lug screws

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 117 118

No comments

HP ProCurve 5400zl User Manual Page 45