HP ProCurve 5400zl User Manual Page 17
- Page / 118
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
1-7
Introducing the ProCurve Series 5400zl Switches
Front of the Switch
Introducing the ProCurve
Series 5400zl Switches
Mgmt
(green/Orange)
On
Off
Blinking
1
A Management module is present and fault free.
The switch is powered off.
There is a fault on the Management module.
PoE
(green/Orange)
On
Off
If any PoE modules are installed.
If no PoE modules are installed.
Blinking
1
Blinking
2
Internal PoE fault.
External load fault or denied PoE power.
Temp
(green/Orange)
Off Switch temperature is normal.
Blinking
1
An over temperature condition has been detected.
Fan
(green/Orange)
On The cooling fans are operating normally.
Blinking
1
One or more of the cooling fans have failed. The switch Fault LED will be blinking
simultaneously.
Internal Power
(green/Orange -
numbers
corresponding to
the power supply
positions)
On A power supply is installed in the position in the back of the switch corresponding to the
number, and the supply is plugged in to an active AC power source. As shipped, the switch
has a single power supply in position 1.
Off A power supply is not installed in the position corresponding to the number.
Blinking
1
The power supply installed in the position corresponding to the number is not plugged in
to an active AC power source, or has experienced a fault. The switch Fault LED will be
blinking simultaneously.
EPS
(green/Orange)
On
Off
An External Power Supply is connected.
No External Power Supply is connected.
Blinking
1
The External Power Supply has a fault, or is connected but not plugged into AC power.
Modules (green -
letters
corresponding to
the switch
module slots)
In PoE Mode:
On A module is installed in the switch module slot corresponding to the letter and the module
is undergoing or has passed self test. This also occurs when you install a module when
the switch is already powered on (“hot swap”).
Off A module is not installed in the switch module slot corresponding to the letter.
Blinking
1
On
Blinking
1
Blinking
2
Off
The module status LED flashes very briefly when a module is being hot swapped. If the LED
flashes for a prolonged time, the module in the slot corresponding to the letter has failed
self test or encountered some other fault condition. See chapter 4, “Troubleshooting” for
a more information.
PoE is ok for this slot.
PoE internal fault for this slot.
PoE load fault or insufficient power for this slot.
The module in this slot is not a PoE module.
LEDs State Meaning
- Installation and 1
- Getting Started Guide 1
- Contents 5
- 4 Replacing Components 6
- 5 Troubleshooting 7
- A Specifications 7
- D Recycle Statements 9
- 5400zl Switches 11
- Front of the Switch 15
- Introducing the ProCurve 17
- Series 5400zl Switches 17
- Table 1-2. Switch Module LEDs 18
- Console Port 20
- Reset Button 20
- Clear Button 20
- Back of the Switch 21
- Power Connector 22
- Redundant Power Supply 22
- Switch Features 23
- Included Parts 25
- Japan Power 26
- Cord Warning 26
- Installation Procedures 27
- Installation Precautions 29
- Cautions 30
- Cabling Infrastructure 31
- Installation Location 32
- 2. Install Switch Modules 33
- Installing the Series 5400zl 34
- Switches 34
- CAUTION: 37
- LED Behavior: 40
- 5.Mount the Switch 41
- Horizontal Surface Mounting 44
- 6. Install the Grounding Wire 45
- to the switch 46
- Power Supply Shelf LEDs 47
- Terminal Configuration 50
- Direct Console Access 51
- Telnet Console Access 51
- Hot Swapping Switch Modules 52
- Example Network Topologies 53
- Use as an Edge Switch 54
- Using the Switch Setup Screen 56
- Where to Go From Here 58
- Management 59
- PoE Status 60
- Replacing Components 61
- Replacing Power Supplies 62
- Replacing Fan Trays 64
- Compact Flash Card 66
- Installing a New Battery 67
- Troubleshooting 69
- Basic Troubleshooting Tips 70
- Diagnosing with the LEDs 72
- Diagnostic Tips: 73
- Proactive Networking 77
- Hardware Diagnostic Tests 78
- Testing Twisted-Pair Cabling 79
- Configuration 80
- Downloading New Code 81
- HP Customer Support Services 81
- Specifications 83
- Environmental 84
- Acoustic 85
- Network Connectors 85
- Switch Ports 87
- Twisted-Pair 88
- Fiber-Optic Cables 89
- Copper Cables 90
- Gigabit-LX 91
- Installing the Patch Cord 92
- Cable Diagram 94
- Pin Assignments 94
- 1000 Mbps Network Connections 96
- Safety Information 97
- Hinweise zur Sicherheit 99
- Safety and Regulatory 100
- Statements 100
- Safety Information (Japan) 102
- Safety Information (China) 103
- EMC Regulatory Statements 104
- European Community 106
- Recycle Statements 107
- Numerics 111
- 2 – Index 112
- Index – 3 113
- 4 – Index 114
- Index – 5 115
- 6 – Index 116
- *5991-4741* 118
© 2020, manymanuals.com. All rights reserved. | 1.371 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals