HP Value 2D Wireless Scanner User Manual download pdf (Page 44)

LED and beeper indications

The scanner’s beeper sounds and its LED illuminates to indicate various functions or errors on the scanner.

An optional “Green Spot” also performs useful functions. The following tables list these indications. One

exception to the behaviors listed in the tables is that the scanner’s functions are programmable, and so may

or may not be turned on. For example, certain indications such as the power-up beep can be disabled using

programming bar code labels.

Indication Description LED Beeper

Power-up Beep The scanner is in the process of

powering-up.

N/A Scanner beeps four times at

highest frequency and volume

upon power-up.

Good Read Beep A label has been successfully

scanned by the scanner.

LED behavior for this indication

is configurable via the feature

“Good Read: When to Indicate”

(see the Programming

Reference Guide for

information).

The scanner will beep once at

current frequency, volume,

mono/bitonal setting and

duration upon a successful

label scan.

ROM Failure There is an error in the

scanner's software/

programming.

Flashes Scanner sounds one error beep

at highest volume.

Limited Scanning Label Read Indicates that a host

connection is not established

when the IBM or USB interface

is enabled.

N/A Scanner 'chirps' six times at the

highest frequency and current

volume.

Scanner Active Mode The scanner is active and ready

to scan.

The LED is lit steadily

N/A

Scanner Disabled The scanner has been disabled

by the host.

The LED blinks continuously N/A

Green Spot

flashes

momentarily

Upon successful read of a label,

the software shall turn the

green spot on for the time

specified by the configured

value.

N/A N/A

Image Capture When ready to capture image. Blue light flashes 2 times when

updating

N/A

Except when in sleep mode or when a Good Read LED Duration other than 00 is selected

Programming Mode - The following indications ONLY occur when the scanner is in programming mode.

INDICATION DESCRIPTION LED BEEPER

Label Programming Mode Entry A valid programming label has

been scanned.

LED blinks continuously Scanner sounds four low

frequency beeps.

Label Programming Mode

Rejection of Label

A label has been rejected. N/A Scanner sounds three times at

lowest frequency and current

volume.

Label Programming Mode

Acceptance of Partial Label

In cases where multiple labels

must be scanned to program

one feature, this indication

acknowledges each portion as

it is successfully scanned.

N/A Scanner sounds one short beep

at highest frequency and

current volume.

38 Appendix B Technical specifications

1 2 ... 39 40 41 42 43 44 45 46 47 48

Comments to this Manuals

No comments

HP Value 2D Wireless Scanner User Manual Page 44

Comments to this Manuals