HP Value 2D Wireless Scanner User Manual download pdf (Page 31)

Figure 4-49 Caps Lock State = Caps Lock ON

Figure 4-50 Caps Lock State = AUTO Caps Lock Enable

Selecting the base interface type

Upon completing the physical connection between the base and its host, proceed directly to “Interface

Selection” below for information and programming for the interface type the base is connected to (for

example: RS-232, Keyboard Wedge, USB, etc.) and scan the appropriate bar code to select your system’s

correct interface type.

Interface selection

The base will support the following host interfaces:

●

RS-232

●

RS-232 OPOS

●

USB

●

Keyboard Wedge

For defaults and additional information associated with each interface, proceed to the corresponding chapter

in the PRG.

Configuring the interface

Scan the programming bar code which selects the appropriate interface type for the system the scanner will

be connected to.

NOTE: Unlike some other programming features and options, interface selections require that you scan

only one programming bar code label. DO NOT scan an ENTER/EXIT bar code prior to scanning an interface

selection bar code.

Some interfaces require the scanner to start in a disabled state when powered up. If additional configuration

is desired in this state, pull the trigger and hold for 5 seconds to change to a state that allows programming

with bar codes.

Figure 4-51 Select RS-232 Standard Interface

Selecting the base interface type 25

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 47 48

No comments

HP Value 2D Wireless Scanner User Manual Page 31