HP Value 2D Wireless Scanner User Manual download pdf (Page 21)

No. Icon LED STATUS

Charging Red On = the Battery is charging.

Charge completed Green On = the Battery is completely charged.

Charging + Charge

completed

Red and Green Blinking together = the Reader is not correctly placed onto the

Base.

Charging the batteries

The battery can be charged by connecting the reader directly to a host through the Micro USB connector

available in the bottom of the handle, as shown below.

Figure 4-10 Micro USB Connector

Alternatively, simply insert the scanner into the base. When the scanner is fully seated in the cradle, it will

sound a “chirp” to indicate that the cradle has detected the scanner connection.

The LEDs on the base (as shown in

Base LEDs on page 14) will indicate the status of the battery.

NOTE: Before using the battery, read “Battery Safety” in the following section. HP recommends annual

replacement of rechargeable battery packs to ensure maximum performance.

Battery safety

To install, charge, and/or perform any other action on the battery, follow the instructions in this manual.

WARNING! Do not discharge the battery using any device except for the scanner. When the battery is used

in devices other than the designated product, it may damage the battery or reduce its life expectancy. If the

device causes an abnormal current to flow, it may cause the battery to become hot, explode, or ignite and

cause serious injury.

Lithium-ion battery packs may get hot, explode or ignite and cause serious injury if exposed to abusive

conditions. Be sure to follow the safety warnings listed in this guide.

Charging the batteries 15

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 47 48

No comments

HP Value 2D Wireless Scanner User Manual Page 21