Hp StorageWorks 2000fc G2 Modular Smart Array User Manual download pdf (Page 90)

90 Managing logical disks (LUNs)

NOTE: If you choose to create a storage pool with fewer than three drives, a message box informs

you that a pool with fewer than three drives does not support fault-tolerant capacity optimized (RAID

5) and asks if you want to continue. Click Yes to continue or No to return to the Create Storage Pool

dialog box to change your selection.

e. Continue with step 6.

4. If the Select Storage Pool for Logical Disk Creation dialog box (Figure 57) opens, complete the

following steps:

Figure 57 Select Storage Pool for Logical Disk Creation dialog box

a. Select one of the existing pool(s) that has space available for a new logical disk by selecting check

box next to the Storage Pool name. (If the pool has no space available, the check box is not visible.)

b. If the subsystem has unused drives, you can select the Create New Pool from available drives check

box to create another storage pool. If you select this check box, the Create Storage Pool dialog box

opens (see step 3) when you click OK.

c. If you want the storage subsystem to select the drives for the new logical disk, select the Do not

create the storage pool... check box near the bottom of the dialog box.

d. To close this dialog box and continue with logical disk creation, click OK. To close the dialog box

without selecting a storage pool, click Cancel.

A message box asks if you want to assign unused drives as spares. If you click Yes, the Assign Spare

Drive dialog box (Figure 58) opens; go to step 5. If you click No, go to step 6.

1 2 ... 85 86 87 88 89 90 91 92 93 94 95 ... 149 150

No comments

Hp StorageWorks 2000fc G2 Modular Smart Array User Manual Page 90