Hp StorageWorks 2000fc G2 Modular Smart Array User Manual download pdf (Page 40)

40 Getting started

13. If Simple SAN Connection Manager detects another unconfigured switch, the New Switch Setup

wizard opens again for that switch and guides you through its setup.

After you have either completed all the steps required in the New Switch Setup procedures (step 4

through step 9), or opted not to set up the switch at this time, the Welcome… Configure Your SAN

dialog box (Figure 19) appears.

Figure 19 Welcome… Configure Your SAN dialog box

14. Select from the following SAN configuration options:

• To prevent the Welcome dialog box from opening every time you start Simple SAN Connection

Manager, clear the Always show this screen at the application startup check box. (Be aware that if

you clear this check box, you cannot later reinstate the Welcome dialog box.)

• To exit this dialog box without performing any configuration, and view the Simple SAN Connection

Manager main window, click Close. (All configuration options offered on this dialog box are also

available from the main window.)

• To launch the Create New Logical Disk wizard and add a new logical disk to your SAN, click

Create Logical Disk Wizard. For details, see either “Creating a logical disk—EVA storage” on

page 84 or “Creating a logical disk—MSA storage” on page 88.

• To open the Perform Other Operations dialog box (Figure 20) and select from additional

configuration options, click Perform Other Operations.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 149 150

No comments

Hp StorageWorks 2000fc G2 Modular Smart Array User Manual Page 40