HP COMPAQ DX2710 MT Technical Information download pdf (Page 46)

6–10 483941-001 Service Reference Guide

Removal and Replacement Procedures— Microtower (MT)/Small Form Factor (SFF) Chassis

5. Locate the memory module sockets.

WARNING: To reduce risk of personal injury from hot surfaces, allow the internal system components to

cool before touching.

6. Open both latches of the memory module socket 1, then insert the memory module into the

socket 2.

Installing a DIMM

✎

A memory module can be installed in only one way. Match the notch on the module with the tab

on the memory socket.

✎

If you have one preinstalled DIMM in socket XMM1 and are adding a second DIMM, it is

recommended that you install an identical DIMM into the XMM2 socket. If you are populating

all four DIMM sockets, use identical DIMMs in each socket. Otherwise, the computer will not

operate in dual channel mode. For maximum performance, populate the sockets so that the

memory capacity of Channel A is equal to the memory capacity of Channel B. For example, if

you have one preinstalled DIMM in socket XMM1 and are adding a second DIMM, it is

recommended that you will install a DIMM of equal memory capacity into the XMM3 or

XMM4 socket.

7. Push the module down into the socket, ensuring that the module is fully inserted and

properly seated. Make sure the latches are in the closed position 3.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 106 107

No comments

HP COMPAQ DX2710 MT Technical Information Page 46