HP ZBook Studio G4 Base Model Mobile Workstation User Manual download pdf (Page 153)

Multi-pin horizontal insert connector (LVDS cable to display panel)

Insert procedure:

1. Slide connector evenly into receptacle on same horizontal plane as PCB connector.

2. Pull lock bar to insert and push both side connector horizontally to rmly lock.

3. Tape down lock bar over the panel to hold in position.

Reverse the procedure above to remove the connector:

1. Remove tape.

2. Pull up bar (pull tape) and release the lock with the PCB connector.

3. Pull to the direction in parallel with PCB to withdraw the connector.

Multi-pin vertical insert connector (LVDS cable to system board)

●

Remove the connector gasket prior to removing the connector.

●

Use at tool under the connector to remove evenly. Do not pull on the cable to remove.

●

Press evenly when reseating/reconnecting/installing the connector.

For more information about cable management, see Cable management on page 139.

Additional information 141

1 2 ... 148 149 150 151 152 153 154 155 156 157 158 ... 181 182

No comments

HP ZBook Studio G4 Base Model Mobile Workstation User Manual Page 153