Hp Insight Management Agents User Manual Page 139
- Page / 177
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
• Other—The Management Agent cannot determine the Advanced Memory Protection fault
tolerance. You may need to upgrade your software.
• None—This system is not configured for Advanced Memory fault tolerance.
• Online Spare Memory— A single spare bank of memory is set-aside at boot time. If enough
ECC errors occur, the spare memory is activated and the memory experiencing the errors is
disabled.
• Mirrored Memory—This system is configured for Mirrored Memory Protection. All memory
banks are duplicated in Mirrored Memory, as opposed to only one for Online Spare Memory.
If enough ECC errors occur, the spare memory is activated and the memory experiencing the
errors is disabled.
• XOR—This system is configured for Advanced Memory Protection using the XOR engine.
• Memory Board—The slot in which the memory board or cartridge is installed.
Other—The value is unsupported or could not be determined.◦
◦ Present—The board or cartridge has memory and is currently online.
◦ Absent—The board or cartridge is offline.
• Board Status—This provides the current status of the Advanced Memory Protection memory
board or cartridge. The following status values are supported:
◦ Other—The condition of this memory board or cartridge could not be determined.
◦ OK—The memory board or cartridge is operating normally.
◦ Degraded—The memory board or cartridge is in an error state. Check for correct memory
installation and that the board has been inserted properly.
• Total Board Memory—This value specifies the size of memory for this board or cartridge,
including memory seen by the OS and the memory used for spare, mirrored, or XOR
configurations.
• Memory in Use—This value specifies the size of memory for this board or cartridge as seen
by the OS.
• Advanced Memory Protection Condition—displays the current condition of the Advanced
Memory Protection subsystem. The following states are supported:
◦ Other—The system does not support fault tolerant memory or the Management Agent
cannot determine the state.
◦ OK—This system is operating normally.
◦ Degraded— The Advanced Memory Protection sub-system has been engaged. Schedule
server down time to replace the deactivated memory.
ROM Microcode Patches
This section displays the following information about ROM Microcode Patches:
• Patch ID—Displays the number of a particular microcode patch.
• Date—Displays the date of a patch's manufacture.
• Family—Specifies the valid family, model, and step that applies to a patch.
• Model—Displays the model number of a patch.
• Step—Displays the revision level of a patch.
Sub-system Classification 139
- Abstract 1
- Contents 3
- 4 Contents 4
- Contents 5 5
- 6 Contents 6
- Contents 7 7
- 8 Contents 8
- Contents 9 9
- Browser requirements 10
- Obtaining JVM from HP.com 11
- Obtaining JVM from Oracle 11
- Security 12
- Security 13 13
- Introduction 14
- Overview 14
- Logging in 14
- System Management Homepage 16
- System Management Homepage 17 17
- Switch to icon view 18
- Body frame 19
- Home tab 19
- Overall System Health Status 20
- Component Status Summary 20
- Management processor 20
- Operating system 21
- System configuration 21
- Version control 21
- Settings tab 22
- UI properties 25
- User Preferences 25
- Tasks tab 26
- Logs tab 26
- Webapps tab 26
- Event Notifier for Windows 27
- 2 Agent information 29
- Threshold Agent 30
- System Agent 30
- System Agent 31 31
- Storage agent 32
- IDE ATA disk drives 33
- 34 Agent information 34
- IDE ATA logical drives 35
- Array Controller Information 36
- Storage agent 37 37
- 38 Agent information 38
- Storage agent 39 39
- 40 Agent information 40
- Storage agent 41 41
- 42 Agent information 42
- Storage agent 43 43
- 44 Agent information 44
- Physical Drive Information 45
- 46 Agent information 46
- Storage agent 47 47
- 48 Agent information 48
- Storage agent 49 49
- Spare Information 50
- Predictive Indicators 51
- Problem Indicators 52
- Failure Indicators 53
- Statistics 54
- Storage agent 55 55
- 56 Agent information 56
- Storage agent 57 57
- 58 Agent information 58
- Storage agent 59 59
- 60 Agent information 60
- Storage agent 61 61
- Tape Drive Information 62
- Storage agent 63 63
- 64 Agent information 64
- Storage Systems 65
- 66 Agent information 66
- Storage agent 67 67
- Storage System Information 68
- Storage agent 69 69
- 70 Agent information 70
- Storage agent 71 71
- 72 Agent information 72
- Storage agent 73 73
- Storage agent 75 75
- Accelerator Information 76
- Storage agent 77 77
- 78 Agent information 78
- 80 Agent information 80
- Storage agent 81 81
- Logical Drive Information 82
- Storage agent 83 83
- Snapshot Resource Volumes 84
- Storage agent 85 85
- 86 Agent information 86
- RAID Array Storage Systems 87
- External Storage Connections 87
- 88 Agent information 88
- Controller information 89
- SCSI device information 90
- Tape library 91
- 92 Agent information 92
- Tape devices 93
- 94 Agent information 94
- CD storage system 95
- Storage systems 96
- SCSI physical drives 97
- 98 Agent information 98
- Drive indicators 99
- Drive statistics 100
- Statistics Preserved 101
- SCSI logical drives 101
- 102 Agent information 102
- SCSI bus information 103
- 104 Agent information 104
- SAS Physical Drive 105
- SAS Host Bus Adapter 105
- 106 Agent information 106
- SAS Logical Drive 107
- 108 Agent information 108
- SAS Tape Drive 109
- SAS Storage System 109
- 110 Agent information 110
- Storage agent 111 111
- Session Information 112
- Connect Information 113
- 114 Agent information 114
- Sub-system Classification 115
- System Information 116
- Sub-system Classification 117 117
- 118 Agent information 118
- Sub-system Classification 119 119
- Memory Summary 120
- Sub-system Classification 121 121
- Memory Details 122
- Processors 123
- PCI Devices 123
- Management Processor 123
- ◦ Degraded 124
- ◦ Failed 124
- Modem/COM Port Settings 125
- Self Test Results 126
- Operating System 127
- Logical Disk Space 128
- Sub-system Classification 129 129
- 130 Agent information 130
- Sub-system Classification 131 131
- Physical Disks 132
- Processes 132
- Processor Utilization 133
- System Configuration 133
- 134 Agent information 134
- ◦ Enabled—Paging will occur 135
- System Board 136
- Sub-system Classification 137 137
- 138 Agent information 138
- Sub-system Classification 139 139
- ◦ Single width module 140
- ◦ Double width module 140
- System Resources 141
- System Summary 141
- Enclosure Information 142
- Server Enclosure 143
- 144 Agent information 144
- Sub-system Classification 145 145
- 146 Agent information 146
- Sub-system Classification 147 147
- Critical Error Log 148
- Correctable errors 149
- Power-On Messages 150
- Integrated Management Log 150
- Operating system overview 151
- Summary page 151
- File System page 152
- User Information page 153
- Connection page 153
- Loaded NLMs page 154
- Server Parameter page 154
- Physical Partition page 155
- Adapter Information page 155
- Mass storage RAID Array 156
- Mass Storage Physical 156
- Mass Storage controller 157
- Mass Storage Summary 158
- Environment Monitoring Unit 158
- External Expansion Cabinet 159
- 5 Support and other resources 160
- HP authorized resellers 161
- Related information 161
- Typographic conventions 161
- 6 Documentation feedback 163
- A Troubleshooting 164
- Known browser issues 165
- SNMP community string issues 166
- Insight Manager issues 167
- Missing NIC information 168
- Other problems 170
- 172 Troubleshooting 172
- 6. Click OK 173
- Glossary 174
- 176 Index 176
Related products and manuals for Software Hp Insight Management Agents
Software Hp Access Control User Manual
(18 pages)
(18 pages)
Software Hp XC System 3.x Software User Manual
(133 pages)
(133 pages)
Software Hp Access Control User Manual
(22 pages)
(22 pages)
© 2020, manymanuals.com. All rights reserved. | 0.200 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals