HP 3PAR User Manual download pdf (Page 19)

Continuing SmartStart Setup

After the Storage System Setup wizard initializes the HP 3PAR StoreServ Storage system, do the

following:

1. Click Finish in the Setup Progress and Results step to exit the Storage System Setup wizard.

NOTE: The wizard continues to run tests in the background after you have exited the Storage

System Setup wizard. If these tests discover any issues, the HP 3PAR Management Console

will display details in the Alert tab that is relevant to the issue.

• To install the Management Console, go to SmartStart wizard step 6, Install the

Management Console.

• For more information about alerts, start the Management Console and open the HP 3PAR

Management Console Online Help.

2. Set up Local Notification. For more information, see “Setting Up Local Notification” (page 19).

3. Validate Remote Support setup. For more information, see “Validating Remote Support”

(page 19).

4. Continue to SmartStart wizard step 3, Connect to the storage system.

Troubleshooting: Adding the Storage System to the Service Processor

If the wizard cannot successfully add your HP 3PAR StoreServ 7000 Storage system to the Service

Processor, use the “Add New InServ” option in the SPmaint module in SPOCC to add the storage

system.

For more information, see the HP 3PAR Service Processor Onsite Customer Care (SPOCC) User’s

Guide. To access this document, go to the HP 3PAR StoreServ Storage site and click the Support

link for your product:

http://www.hp.com/go/3par

Setting Up Local Notification

Local Notification configures your HP 3PAR StoreServ Storage system to email you alerts as issues

occur (for example, if a CPG becomes low on space, a disk drive fails, and so on). To set up Local

Notification:

1. Enter your Service Processor network address.

2. Click Setup.

3. Click Enable Local Notification.

NOTE: A mail host must also be configured in order to completely enable Local Notification.

For more information about Local Notification setup, see the HP 3PAR Service Processor Onsite

Customer Care (SPOCC) Online Help. For more information about alerts, see the HP 3PAR

Management Console Online Help.

Validating Remote Support

Remote Support validation is done as a part of the Service Processor setup. If you need to re-run

the Remote Support validation, you can use the SPmaint module in HP 3PAR Service Processor

Onsite Customer Care (SPOCC).

1. Log in to SPOCC (https://<SP IP>) using the 3parcust user account.

2. Click SPmaint→Network Configuration→Test 3PAR Secure Service Collector Server.

3. Verify that SPOCC displays Connectivity test to HP 3PAR Secure Service Collector Server

successful.

4. Verify that the Service Processor is transferring files successfully:

Continuing SmartStart Setup 19

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 62 63

Comments to this Manuals

No comments

HP 3PAR User Manual Page 19

Comments to this Manuals

Related products and manuals for Software HP 3PAR