HP 3PAR User Manual download pdf (Page 10)

◦ The HP 3PAR storage system setup is verified, the storage system is powered on, and the

LEDs are functioning correctly.

◦ Either the physical Service Processor is installed and powered on and you have assigned

it an IP address, or the virtual Service Processor is installed and connected and you have

determined the temporary IP address.

• Make sure you have the following:

Administrative access to the Windows host systems you are configuring

If you are planning to configure a remote host system (a machine other than the machine

into which you inserted the SmartStart media), you must be able to use the same ID and

◦

password to gain administrator access to both the system running SmartStart (the local

host) and the remote host.

◦ Rights to configure storage

To configure storage, your user account on the HP 3PAR storage system must either be

assigned a Super user or Edit role or be granted the following rights:

– host_create

– vv_create

– vlun_create

◦ The necessary Service Processor and HP 3PAR storage system information for initialization

and configuration

For more information, see your completed Storage System Software Installation Checklist

from the HP 3PAR StoreServ 7000 Site Planning Manual.

– Service Processor information

The Service Processor IP address, subnet mask, and gateway IP address

For more information about determining the temporary IP address and assigning

the permanent IP address, see the HP 3PAR StoreServ 7000 Storage Installation

Guide.

–

– Host name to assign

– DNS settings (if applicable)

– Proxy server settings (if applicable)

– New password to assign to the user account for the two Storage System Setup

wizards (setupusr)

– New password to assign to the user account for the Service Processor (3parcust)

NOTE: Passwords for the setupusr and 3parcust user accounts must be between

7 and 32 characters in length and can consist of alphanumeric characters and

the following special characters: period (.), plus sign (+), dash (-), equals sign

(=), and forward slash (/).

– HP 3PAR StoreServ Storage system information

– Storage system serial number

This seven-digit number is located on the back of your HP 3PAR StoreServ Storage

system next to the power switch for the node enclosure power cooling module

(PCM1). It begins with “16” (for example, 1624635). For more information,

see “Locating the Serial Number” (page 17).

– Storage system name

10 Prepare to Configure

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 62 63

Comments to this Manuals

No comments

HP 3PAR User Manual Page 10

Comments to this Manuals

Related products and manuals for Software HP 3PAR