HP 3PAR User Manual download pdf (Page 30)

Configure the iSCSI Target

1. Select the IP address of the iSCSI initiator on the host system.

2. Click Configure.

3. Click Next.

Troubleshooting the iSCSI Connection

If the iSCSI initiator on the host system cannot connect to the HP 3PAR StoreServ Storage system,

verify your configuration:

1. Verify your IP settings:

• IP address

• Subnet mask

• Gateway

2. Check your iSCSI connection. To do this, ping the HP 3PAR StoreServ Storage system from

the host.

Troubleshooting Task Completion

If SmartStart displays the Failed to validate whether the current Windows task is complete message,

click Configure again.

If the problem persists, contact HP support. For more information, see “Support and Other Resources”

(page 57).

Install and Start Host Explorer

Host Explorer helps you discover and manage host system paths. Installation is optional. If you do

not install Host Explorer, you must manually manage host paths. For more information, see “The

Host Explorer Software Agent” (page 44).

To install HP 3PAR Host Explorer:

1. Click Install.

2. Click Next.

Summary: iSCSI Host Configuration

1. Review your iSCSI setup.

2. Click Finish.

Configuring Multiple iSCSI Ports

To configure another iSCSI port:

1. Go to SmartStart wizard step 4, Configure hosts.

2. Click Configure iSCSI hosts.

3. In steps 1 through 4 of the iSCSI Host Configuration wizard, configure the same iSCSI host

system.

4. At iSCSI Host Configuration wizard step 5, Configure the iSCSI port, select an additional port

and configure it.

5. In the final steps of the iSCSI Host Configuration wizard, complete the iSCSI configuration for

this host.

30 Configure the Hosts

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 62 63

No comments

HP 3PAR User Manual Page 30