HP 3PAR User Manual download pdf (Page 17)

3 Setting Up the HP 3PAR StoreServ Storage System

Before you can configure the HP 3PAR StoreServ Storage system, you must initialize it. The Storage

System Setup wizard verifies your HP 3PAR storage system configuration, initializes the storage

system, and runs initialization tests on the storage system.

To set up and configure the HP 3PAR storage system:

1. Verify that the Service Processor is on the same subnet of the network as the HP 3PAR StoreServ

7000 Storage system you are setting up.

2. Click the Set up the Storage System link in SmartStart wizard step 2, Set up systems.

3. Enter the permanent Service Processor IP address. For more information about Service Processor

IP addresses, see the HP 3PAR StoreServ 7000 Storage Installation Guide.

4. Enter the user name setupusr.

5. Enter the password for setupusr that you created in the Service Processor Setup wizard.

Troubleshooting Access

If you cannot access the Storage System Setup wizard, collect the relevant log files and contact

HP support. For more information, see “Troubleshooting System Setup” (page 20).

Locating the Serial Number

The serial number on your HP 3PAR StoreServ Storage system is the seven-digit number located

on the back of the storage system next to the power switch for the node enclosure power cooling

module (PCM1). It begins with “16” (for example, 1612345).

Locating the Serial Number 17

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 62 63

No comments

HP 3PAR User Manual Page 17