HP xw6400 User's Guide download pdf (Page 139)

Screen message Probable cause Recommended action

162—System Options Not Set Configuration incorrect. RTC battery

might need to be replaced.

1. Run Computer Setup (F10 Setup).

2. Set the date and time under Control Panel or in

F10 Setup depending on the operating system.

3. If the problem persists, replace the RTC battery.

163—Time and Date Not Set Invalid time or date in configuration

memory.

RTC battery might need to be

replaced.

CMOS jumper might not be properly

installed.

1. Set the date and time under Control Panel or in

F10 Setup depending on the operating system.

2. If the problem persists, replace the RTC battery.

164—Memory Size Error Memory configuration is incorrect. 1. Run Computer Setup (F10 Setup) or Windows

utilities.

2. Be sure memory modules (if any) are installed

properly.

3. If third-party memory has been added, test using

HP memory only.

4. Verify proper memory module type.

183—Invalid Processor

Jumper Setting

System board jumper improperly set. Reset system board jumpers to match processor and

bus speeds (select models).

201—Memory Error RAM failure. 1. Run Computer Setup (F10 Setup) or Windows

utilities.

2. Be sure that memory and continuity modules are

installed correctly.

3. Verify proper memory module type.

4. Remove and replace memory modules one at a

time to isolate faulty module.

5. Replace the faulty memory modules.

6. If error persists after replacing memory modules,

replace the system board.

202—Memory Type Mismatch Memory modules do not match each

other.

Replace memory modules with matched sets.

207—ECC Corrected Single

Bit Errors in Memory Socket(s)

y,y

Single-bit ECC error. 1. Verify proper memory module type.

2. Insert the DIMM in another memory socket.

3. Replace memory module if problem persists.

212—Failed Processor Processor has failed to initialize. 1. Reseat the processor in its socket.

2. If the processor does not respond, replace it.

213—Incompatible memory

Module in memory Socket(s)

X,X, X

A memory module in memory socket

identified in the error message is

missing critical SPD information or is

incompatible with the chipset.

1. Verify proper memory module type.

2. Insert the DIMM in another memory socket.

3. Replace memory with a module conforming to the

SPD standard.

Table 5-18 POST error messages (continued)

ENWW POST and error messages 129

1 2 ... 134 135 136 137 138 139 140 141 142 143 144 ... 207 208

Comments to this Manuals

No comments

HP xw6400 User's Guide Page 139

Comments to this Manuals

Related products and manuals for Server/workstation motherboards HP xw6400