Hp 170X User Manual download pdf (Page 20)

2-4 Hardware Installation

If you want to change the detected printer language, use the LEDs

and Test button to select a PDL for the configuration page. When

you hold down the Test button for three seconds, the LEDs begin to

cycle through four configurations, as outlined in the following table.

Release the Test button when you get the right PDLs, and the

configuration page will be printed.

When you first press the Test button, the Status and Activity LEDs

are on and solid for about 3-4 seconds. Then they switch off,

indicating they are cycling through the PDLs.

Resetting to Factory Defaults

Once you have configured the HP JetDirect external print server,

the configuration settings are retained in memory unless you

manually reset them.

(The firmware is not affected when you reset the configuration

settings.)

To reset the configuration settings to their factory defaults, follow

these steps:

1. Unplug the power cord from the print server.

2. While holding down the Test button on the print server, plug the

power module into the print server and continue to hold down

the Test button for five seconds. All previous configuration

settings will be erased.

For PDL...

The Status

LED is...

And the Activity

LED is...

HP PCL (default) Off Off

ASCII Off On

Postscript On Off

HP-GL/2 On On

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 29 30

No comments

Hp 170X User Manual Page 20