HP ap5000 All-in-One Point of Sale System User Manual download pdf (Page 67)

9. Remove the five screws that secure the display head to the display head housing. Two of the

screws are located under the bottom I/O cover. The third screw is located under the drive cover.

The fourth screw is located under the MSR. The fifth screw is located below the touch screen

hinge.

NOTE: Some models may have only four screws. The center screw shown below may not be

included.

Figure 7-24 Removing the Display Head Screws

10. Lift the bottom side of the display head housing (where the two screws were removed) off the

touch screen (1), then lift the top side off the housing off the touch screen (2).

Figure 7-25 Removing the Display Head

11. Locate the memory module sockets on the system board.

WARNING! To reduce risk of personal injury from hot surfaces, allow the internal system

components to cool before touching.

Installing Additional Memory 59

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 88 89

No comments

HP ap5000 All-in-One Point of Sale System User Manual Page 67