HP 706C User Manual download pdf (Page 46)

 

Configuration changes are made through the master configuration

port which is the highest numbered port on all models. Print Master

will transmit configuration menus to the serial device connected to the

master configuration port on all models except the 706A and 708A.

The 706A and 708A will print out configuration menus on a parallel

printer connected to Port 1 as described in

Section 7.1

. If you are

configuring a 700C unit, please see

Section 7.2

. If you are

configuring a 700D, 700E, or 700F unit, please see

Section 7.3

  "



Please use the following procedure to access configuration mode of

the 706A or 708A and to program all the various features:

1. Connect a computer with a parallel port such as an IBM PC or

compatible to Port 6 of the 706A or Port 8 of the 708A.

Connect a printer with a parallel port to Port 1 of either unit.

Please see

Section 5.1

and

Appendix A.4

for parallel cabling

information.

Since configuration must be performed through a parallel port

and since parallel communication is unidirectional,

configuration menus must be printed out on your printer.

2. The computer must be in a mode that allows characters to be

sent from the keyboard to the parallel port. To put your

computer into this mode, Bay Tech provides a utility program

(PARSEND)

or a suggested program to run using MS BASIC

(see

Section 4.2

.).

NOTE:

Make sure the keyboard of your computer is in the

CAPS LOCK position.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 122 123

No comments

HP 706C User Manual Page 46