HP 706C User Manual download pdf (Page 29)

 #%#



Individual ports on Print Master may be configured as computer or

printer via the Number of Printers/Port Assignment. Computers

connect to computer ports. Printers and plotters connect to printer

ports.

On all models, a minimum of one port must be assigned as a printer

port and a minimum of one port must be assigned as a computer port.

It is suggested that the highest numbered port, the master

configuration port, be assigned as a computer port to allow easy

access to all features of the configuration mode. The remaining ports

may be user-designated as computer ports or printer ports in any

combination except for the 700A and 700C models. Print Master

automatically converts data from serial-to-parallel and parallel-to-

serial.

On the 700A and 700C models, ports are assigned by defining the

Number of Printers. Printer ports are assigned to the lowest

numbered ports. For example, if the Number of Printers is 1, Port 1 is

the printer port and the remaining ports are computer ports. If the

Number of Printers is 3, Ports 1, 2, and 3 are printer ports and the

remaining ports are computer ports.

On 700D, 700E and 700F models with combination serial/parallel

ports, ports are defined by configuring the Port Assignment for

individual ports to computer or printer. Any serial or parallel port may

be assigned as a computer port or printer port.

NOTE:

On Print Master models 710C, 710E and 710F, Port 10 may

not be assigned as a printer port.

The factory default printer port on all Print Master models is Port

1 and all other ports are assigned as computer ports.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 122 123

No comments

HP 706C User Manual Page 29