HP 706C User Manual download pdf (Page 31)

 #

NOTE:

This section is not applicable to the 706A or 708A models.

Print Master will translate for serial devices using different

configurations. You may set the baud rate, word size, stop bits, parity

and XON/XOFF for each individual serial port. The available values

for these parameters are listed in

Section 2

(Specifications).

Factory default configuration on all serial ports is 9600 baud rate,

8 word size, 1 stop bit, no parity and XON/XOFF disabled.

 #&

The input inactivity timeout allows Print Master to disconnect a

computer from the unit if no characters are received from the

computer for the specified timeout period.

Some application packages may have rather lengthy processing delay

times between successive parts of the same file when printing. These

delay times may exceed the factory default input inactivity timeout

value of 20 seconds. Therefore, it may be necessary to increase the

timeout to a higher value. Typical applications which may require a

higher timeout would be ones which involve desk-top publishing,

heavy graphics, and large text files with imbedded soft fonts.

Factory default is 20 seconds.

 #

Print Master has four form feed modes which allow you to send a form

feed to the selected printer. A form feed may be sent at the beginning

of printing, at the end of printing, at the beginning and end of printing,

or disabled (no form feed).

Factory default is no form feed.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 122 123

No comments

HP 706C User Manual Page 31