HP 10BASE-T Installation Manual download pdf (Page 5)

HP AdvanceStack 10BT Switching Hubs Installation Guide

2. Partially install a screw (5/8-inch number 12-24) into the top hole of a pair of holes 0.5 inches

apart in each rack/cabinet upright. Tighten each screw two turns. Ensure that the screws in

each upright are at the same level.

3. Place the hub in the rack and lower it so the notches in the bottom of the bracket slide onto the

screws. Tighten these screws-be careful not to overtighten.

Upper hole in the bracket

Lower notch in the bracket

0_INSTAL.FM5 Page 5 Friday, August 9, 1996 4:28 PM

1 2 3 4 5 6 7 8 9 10 ... 15 16

No comments

HP 10BASE-T Installation Manual Page 5