HP 10BASE-T Installation Manual download pdf (Page 14)

HP AdvanceStack 10BT Switching Hubs Installation Guide

Where to Go From Here

Your hub is now correctly installed and is able to send and receives data between end nodes, servers,

and printers. Depending on your setup, use this table to determine what steps need to be taken next.

If you need to set the IP address, see the Management Module manual for information on how to use

the ASCII console or HP AdvanceStack Assistant. For a Novell Netware network, no configuration

is necessary.

Your Hub Setup Detailed Description Communication Status What You Need to Do

One hub or stack of 2 or

more hubs with:

- No Management Module

- No Switch Module

All users are on seg-

ment 1 and can com-

municate together.

No software configuration needed.

If Act or Col LEDs are on all of the time,

add a Management Module and exter-

nal switch or Switch Module to distrib-

ute ports evenly over the four segments.

Stack of 2 or more hubs

with:

- Management Module

- Switch Module

All users are distribut-

ed evenly over seg-

ments 1, 2, 3, and 4 and

can communicate to-

gether.

No software configuration or optimiza-

tion needed.

Stack of one or more hubs

with Management Module

only

All users are on seg-

ment 1 and can com-

municate together.

If Act and Col LEDs are on most of the

time, segment your stack by either:

-adding a Switch Module

-adding more LAN adapters to the

servers.

- adding an external switch.

If you only add a Management Module

and move the ports to other segments in

software, remember that users

cannot

communicate between the segments.

Add an external switch or Switch Mod-

ule to this stack for communication be-

tween all the segments.

Switch in back

Mgmt.

Mgmt

0_INSTAL.FM5 Page 14 Friday, August 9, 1996 4:28 PM

1 2 ... 9 10 11 12 13 14 15 16

Comments to this Manuals

No comments

HP 10BASE-T Installation Manual Page 14

Comments to this Manuals

Related products and manuals for Networking HP 10BASE-T