1HP AdvanceStack 10BT Switching Hubs Installation GuideThe Switching Hubs are a family of multiport repeaters. With these hubs you can connect com
10 HP AdvanceStack 10BT Switching Hubs Installation GuideConnecting Network CablesUsing RJ-45 ConnectorsIf the Port LED is not on, use this table t
11HP AdvanceStack 10BT Switching Hubs Installation GuideUsing Telco Connectors with the Hub-24TIf you prefer to make your twisted-pair connections
12 HP AdvanceStack 10BT Switching Hubs Installation GuideTo use a telco connector:To remove a telco connector, reverse this process.AUI/Xcvr SlotAn
13HP AdvanceStack 10BT Switching Hubs Installation Guidemust be disabled on the transceiver. Cable ManagementThe HP Switching Hubs have been desig
14 HP AdvanceStack 10BT Switching Hubs Installation GuideWhere to Go From HereYour hub is now correctly installed and is able to send and receives
0_INSTAL.FM5 Page 15 Friday, August 9, 1996 4:28 PM
© 1996 Hewlett-Packard CompanyHP Part Number: 5964-4661Edition 1, August 1996Printed in Singapore.*5964-4661* Technical information in this document i
2 HP AdvanceStack 10BT Switching Hubs Installation GuideVerify Included PartsEach of the three HP Switching Hubs has the following components shipp
3HP AdvanceStack 10BT Switching Hubs Installation GuideInstall Any Optional ModulesInstall optional modules into the Management Slot or the Expans
4 HP AdvanceStack 10BT Switching Hubs Installation GuideMount the HubAfter the modules are inserted, you are ready to put the hub in a stable locat
5HP AdvanceStack 10BT Switching Hubs Installation Guide2. Partially install a screw (5/8-inch number 12-24) into the top hole of a pair of holes 0
6 HP AdvanceStack 10BT Switching Hubs Installation Guide4. Install the other number 12-24 screw into the upper hole in each bracket. Tighten these
7HP AdvanceStack 10BT Switching Hubs Installation GuideMounting the Hub on a WallYou can put one hub on a wall or stack two hubs together on a wal
8 HP AdvanceStack 10BT Switching Hubs Installation GuideConnecting the Switching Hubs Together with Extender CableAttach the included Extender Cabl
9HP AdvanceStack 10BT Switching Hubs Installation Guide2. If you are not using an RPS, plug the included power cord into the hub’s power cord rece
Comments to this Manuals