WARNING!
The blower motor does not stop immediately when the blower power is removed. Keep your fingers
away from the blower blades until the motor stops.
To remove a blower:
While pushing in on the two mounting tabs (Figure 32-1), pull the blower (Figure 32-2) away from
the power supply.
1. Mounting tabs (2)
2. Blower
Figure 32 Removing a blower
Replacing a blower
CAUTION:
Pressing on the center section of the blower can damage the blades or the housing. Only press on
the outer edge of the blower.
To replac
eablower:
1. Align the blower guide post (Figure 33-2) with the mounting hole next to the power supply
connector (Figure 33-1).
2. Slide the
blower onto the blower base (Figure 33-4) until the mounting tabs (Figure 33-3)
snap into place.
3. Verify that the blower starts and the power supply/blower assembly LED is on.
2500 Disk System user guide
59
Comments to this Manuals