HP StorageWorks 2500 Disk System Enclosure User Manual download pdf (Page 58)

Figure 30 Re

moving a power supply

Replacing a power supply

To replace a power supply:

1. Align the power supply with the enclosure opening.

2. Lift the module latch (Figure 31-1) and slide the power supply into the enclosure until it is

fully seated.

3. Remove the blower from the defective power supply and install it on the replacement power

supply (see "Removing a blower"onpage58).

4. Connect the power cord to the power supply and engage the power cord lock.

5. Verify that the blower starts and the power supply/blower assembly LED is on.

Figure 31 Replacing a power supply

Removing a blower

You c

an replace the blower without removing the power supply.

Customer self repair

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 88 89

HP StorageWorks 1
2500 Disk System user guide 1
Legal and notice information 2
Contents 3
Rack stability 10
HP technical 10
Customer self repair 11
Subscription service 11
Other HP web sites 11
Documentation feedback 11
About this guide 12
1Overview 13
Components 14
Status i 15
System requirements 15
Hard disk drive firmware 16
Disk drive 16
2Components 17
Controls and d 18
I/O modules 19
1. Status LEDs 20
2. Port 2 20
3. Port 1 20
20 Components 20
Features 21
Fibre Channel disks 22
Cables and cabling 24
Transceivers 24
3 Installation 25
Installing th 26
Installation 28
Reducing the enclosure weight 29
Removing the EMU 30
Removing the I/O modules 31
CXO7373A 33
Verifying the installation 36
Adding driv 36
4UsingtheEMU 39
Loop ID (Li) 40
Audible alarm (Au) 41
Firmware revision (Fr) 42
Error condition report (Er) 42
Using the EMU 44
5 Troubleshooting 45
EMU error condit 48
Status indicators 48
Audible error indicators 50
Visual error indicators 50
Disk drives 51
Catastrophic errors 52
EMU temperat 53
Troubleshooting 54
6 Customer self repair 55
Verifying component failure 56
Procuring the spare part 56
Returning the defective part 57
Before you begin 57
Removing a power supply 57
Replacing a power supply 58
Removing a blower 58
Replacing a blower 59
Replacing a disk drive 60
ASpeciﬁcations 63
Power specifi 64
Table 18 Out 65
Table 19 65
Power speciﬁcations 65
Specifications 66
B Regulatory notices 67
Laser devices 68
Certification a 69
WEEE Recycling N 70
Finnish notice 71
French notice 71
German notice 71
Greek notice 71
Hungarian notice 72
Italian notice 72
Latvian notice 72
Lithuanian notice 72
Polish notice 73
Portuguese notice 73
Slovenian notice 73
Germany noise declaration 74
Japanese notice 74
Taiwanese notice 75
Japanese power cord notice 75
Regulatory notices 76
Error condition report format 77
Correcting err 78
Temperature error conditions 80
EMU error conditions 81
Transceiver error conditions 82
CXO7461A 83
Backplane error conditions 84
I/O module error conditions 84

Comments to this Manuals

No comments

HP StorageWorks 2500 Disk System Enclosure User Manual Page 58

Comments to this Manuals

Related products and manuals for Network transceiver modules HP StorageWorks 2500 Disk System Enclosure